Also, size of the granules and perforations can vary slightly. Users browsing this forum: No registered users and 5 guests, Nosler Inc | Privacy Use Order Processing. Chrono'd my Remington 700 300 win mag (5R) 26" barrel with 200 gr accubonds today and was amazed to see 2741 fps. If you are interested in the most recent data for cartridges and/or bullet weights/styles not listed on this page, contact Barnes Consumer Service department to inquire about recommended loads and approximate timing for the data to be made available via email at customerservice@barnesbullets.com or by phone at 800.574.9200.. I am shooting a Tikka T3. 73-74gr of RL22 will get you 2850-2950FPS out of your 24" barreled 300 Win. The load data from nosler doesn't list the 300 win mag, just a 300 win. Sierra says 73.8 and Hodgdon says 74.0 as a max. Thanks for the reply I have that manual I was hoping some one had the data form the #8 manual that includes more powders specifically reloader 17, It is currently Mon Nov 02, 2020 10:29 pm. Just need some in site as to what you guys think. H4831 a lot of it. In my Remington 700 LR .300 win mag with a 26" 1:10 twist factory barrel, I was getting 1/2moa or better today. 107 SW Columbia St | Bend, Oregon, USA 97702 | Toll Free: 1-800-285-3701 | catalog@nosler.comNosler Showroom / Open to the Public: Monday - Friday 10:00 am to 5:30 pm PSTCorporate Hours: Monday - Friday 8:00 am to 4:30 pm PST, Copyright 2013 - 2020Nosler Inc | Privacy Use Order Processing, Nosler - Bullets, Brass, Ammunition & Rifles. In my experience the Ballistic Tip hunting bullets need to impact 3000 fps or slower to work well no matter what caliber. No data for you for the long 300 my experience is with the WSM. It was about 71 degrees outside in Dallas, TX- not sure of elevation, but probably between 700-750ft above sea level. Founded by Frank Galli in 2014, Sniper’s Hide has been offering informational videos, podcasts, and other support to it’s users in one location. The 150gr partition did though. The burn rate can vary from lot-to-lot. I tried to get the 150gr Ballistic tip to work but my rifle just did not like them. He made one jump and landed on his nose, DRT. ATTENTION: New reloading data … H1000 does great also. I just tried the RL-25 in my Remington 700 with R-P brass, CCI 250 primers, 75 gr RL-25 , 200 AB and groups are great. The 300 Win Mag’s short case neck is not detrimental to accuracy, and it is actually capable of near bench-rest like groups with the proper load in a high quality rifle.
I have new federal brass and magnum primers and imr 4350 and imr 4830. Here is what I have. 300 Win Mag Load Data.
Base to tip measured 3.550" with Nosler brass, Fed 215, 78.8 grains of H1000 and the 180 grain Accubond. .300 Winchester Magnum (Using 175/180 GR Nosler Bullets) reloading data with 30 loads. http://cgi.ebay.com/Reloading-Manual-for...1QQcmdZViewItem. Scotty. Using bullets from Nosler Partition Spitzer or AccuBond.
Hey guys looking for a load for my 300 win mag. I am getting 2900+ out of my 300WM w/24" tube and 200gr GK's. Avg velocity today was 2963 fps. Total devistation. 107 SW Columbia St | Bend, Oregon, USA 97702 | Toll Free: 1-800-285-3701 | catalog@nosler.comNosler Showroom / Open to the Public: Monday - Friday 10:00 am to 5:30 pm PSTCorporate Hours: Monday - Friday 8:00 am to 4:30 pm PST, Copyright 2013 - 2020Nosler Inc | Privacy Use Order Processing, Nosler - Bullets, Brass, Ammunition & Rifles.
Thanks in advance ! I'd start a grain or two less than max, and work up. In the 300 Winnie it won quite a few competitions at 1000 yards. Scotty. +1 on RL22.
RL22 and 200's seems to work in just about every 300WM I have tried it out of. In my Remington 700 LR .300 win mag with a 26" 1:10 twist factory barrel, I was getting 1/2moa or better today.
Load Data: 30 Caliber Loading / Reloading Information. 115 SW Columbia St | Bend, Oregon, USA 97702 | Toll Free: Nosler Showroom / Open to the Public: Monday - Friday 10:00 am to 5:30 pm PST, http://www.nosler.com/nosler-load-data/ ... er-magnum/. Accubond.
Load Data.
Sniper’s Hide is a community of Snipers of all kinds, focusing on long range shooting, accuracy, and ballistics.
This is the suggested accuracy load out of one of the older Sierra manuals.
I have found that 74.2 grs IMR 4350 with 150s is usually really accurate in the 300 Win mag. 115 SW Columbia St | Bend, Oregon, USA 97702 | Toll Free: Nosler Showroom / Open to the Public: Monday - Friday 10:00 am to 5:30 pm PST, http://www.nosler.com/nosler-load-data/ ... er-magnum/.
Top of the line performance matched with a top notch customization features. Start lower and work up to what your rifle likes. I had very good accuracy, .75 moa, with 80 grains of R22 in Winchester case and cci250. I am going to work up to the same load with the 200gr PT. Looks like case could be solved Nosler book page 404 is about 24 - 120 fps faster then IMRPowder site rating for their powders looks like measurement difference. I have hunted in north east NC for 30+ years where there are a lot of deer and I helped do crop damage work on a big farm where my buddy and I took 100 deer a year for 15 years. That isn't far off what I get with 73gr's so you sound pretty good to me. I'm looking for load data for nosler 190 gr accubond long range in 300 win mag for the following powders reloaded 22, reloaded 17, h1000, and imr 7828.
Everyone that I know moved up to the 165 & 180 gr BT and have no regrets. Its anywhere from 3000-3100fps and well under 1 MOA in many different rifles. 112 fps slower? Need a bit of help. If you want to shoot a 150 gr bullet go to the Accubond.
If you want to shoot a 150 gr bullet go to the Accubond. The composition is somewhat complex in that while proportionality of deterrents and other compounds added to the propellant are constant, adherence can vary. JavaScript is disabled.